Descrizione annuncio

DRIVER Celestion - CDX20-3075 75W 8ohm - HF Compression Driver - Ferrite Driver a compressione con magnete in ferrite, uscita da 2", potenza 75Watt, impedenza 8ohm, diaframma in titanio, fissaggio con viti (bolt). Caratteristiche - 2" exit, ferrite magnet, 3" voice coil compression driver provides 75Wrms (AES standard) power handling and 107dB sensitivity - Patented phase plug design method suppresses cavity resonances at higher frequencies - Titanium diaphragm, deep drawn to increase stiffness and reduce distortion - Lower compression ratio reduces air non-linearity and allows for higher maximum SPL - Rolled polyimide surround improves stiffness control, further lowering distortion - Curved coherent wavefront, optimised for horn loading Specifiche Generali Power rating(1): 75Wrms Continuous power rating(2): 150W Nominal impedance: 8ohm Frequency range: 500-18,000Hz Sensitivity(3): 107dB Recommended min. crossover (12dB/oct): 800Hz Voice coil diameter: 75mm/3in Voice coil material. Edgewound copper clad aluminium Magnet type: Ferrite Diaphragm material: Titanium Surround material: Polyimide Informazioni di Montaggio Width: 180mm/7.09in Depth: 71mm/2.8in Weight: 4.8kg/10.6lb Fitting: Flange (4 x M6 holes on 10mm/4inch PCD) Throat exit: 50mm/2in Note (1)Tested for two hours on plane wave tube using a continuous, band-limited pink noise signal as per AES standard. Power calculated on minimum impedance. (2)Continuous Power Handling is defined as 3dB greater than the AES rating. (3)Measured on axis at 1W, 1m, using typical horn, in 2 anechoic environment. Per stampare la scheda prodotto, clicca qui Per una panoramica su tutta la serie Celestion CDX Ferrite, clicca qui Per consultare e scaricare la brochure originale Celestion Pro Audio, clicca qui